Process Network Cyber Security provides the following Services:

Documentation/Design/Planning

  • Front End Loading Network and Cybersecurity Consulting and Support (FEL)
  • Front End Engineering Design Network and Cybersecurity Consulting and Support (FEED)
  • Network Functional Design Specification (FDS)
  • Network Detailed Design Specification (DDS)
  • System Detailed Design Specification (DDS)
  • Active Directory Detailed Design Specification (DDS)
  • TCP/IP Address Detailed Design Specification (DDS)
  • System Backup Detailed Design Specifcation (DDS)
  • Cable Schedule creation for Copper and Fiber Inside Plant Connections
  • Network Architecture Block Diagrams
  • Network and Server Cabinet Layout Diagrams
  • Overall Network Architecture Design
  • Per Unit or Community Level Architecture Design
  • Cybersecurity Policy Creation and Support
  • Power and Heat Load Calculations for Network and Server Cabinets
  • Network Pre-Cutover Planning, Documentation and Execution
  • Network Cutover Planning, Documenation and Execution
  • As-Built Documentation (Post Implementation)

 

Network

  • Network Assessment – Gap Analysis (Current State and Future State Look Ahead)
  • Network Design, Configuration and Implementation to ISA-99/ISA-62443 Standards
  • Network Performance Quality Enhancement Assistance
  • Network Managment Server (NMS) Planning and Implementation
  • Network Troubleshooting
  • GPS and NTP Time Synchronization
  • Network and System data and timestamp logging implementation
  • Fiber Optic Requirements for Remote Instrument Enclosure (RIE) / Remote Building Connectivity to Control Room (Singlemode / Multimode)
  • Copper and Fiber Ethernet wiretag labeling
  • Netflow Collector Analyzer Configuration (Router and Server Side)

 

Cybersecurity

  • Cybersecurity Assessment  – Gap Analysis (Current State and Future State Look Ahead)
  • Vulnerability Assessment – Perform Scan of open ports and services open to the Business Network identify vulnerabilities
  • Securing Modbus, OPC, DNP3 and other typical SCADA / DCS communication protocols
  • Securing the transfer of historical data from the Process Control Network to the
    Business Network
  • Firewall Access Control List (ACL’s) Scope, Planning and Implementation (Cisco/Juniper/Palo Alto)
  • Intrusion Detection Systems (IDS) Scope, Planning and Implementation
  • Intrusion Prevention Systems (IPS) Scope, Planning and Implementation
  • Domain Group Policy Hardening (Active Directory)
  • Network Device Hardening (Routers, Switches and Firewalls)
  • Two-Factor (2FA) Authentication Configuration and Implementation (Server and Network Side) with either TACACS or RADIUS
  • Domain Controller Design and Implemenatation
  • Physical and Virtual Server Design, Configuration and Support
  • Anti-virus and Patch Management Planning and Implementation
  • Application Whitelisting
  • System Troubleshooting

 

Other Services

  • End User and Asset Owner-Operator Consulting, Support (also Advisory role)
  • Engineering, Procurement and Contruction (EPC) Consulting and Support (also Advisory role)
  • Main Automation Contractor (MAC) consulting and Support (also Advisory role)
  • Offshore Platform Topside and Subsea Network Design, Troubleshooting and
    Implementation Support
  • Pre-FAT (Factory Acceptance Test) Support
  • FAT (Factory Acceptance Test) Support
  • Outage / Turnaround Network and System Support
  • System Testing
  • Commissioning Support
  • Handover Support
  • Process Network and Cybersecurity Training
  • Staff Augmentation (Short to Long Term Onsite Support)
  • Disaster Recovery Planning and Implementation
  • Emergency Call-Out Troubleshooting for Network and Systems (24×7 On-call Support
    available)

____________________________________________

Share This Page!